| Code | Meaning (Old Manual) | Meaning (Updated Manual) | Solution | | :--- | :--- | :--- | :--- | | | Overcurrent | Phase imbalance on input | Check wall outlet voltage. Requires 220V ±10%. Use a multimeter. | | E-07 | Sensor fail | Hall effect sensor gap >2mm | Remove the side cover. Push the sensor bracket toward the magnetic ring until gap is 1.2mm. | | E-12 | Temp high | Motor winding >130°C | Stop for 45 minutes. Do not just reset; clean the cooling fins. | | E-19 | Brake error | DC injection voltage low | Replace the bridge rectifier (Part #40268-19). Do not run until replaced. | | F-03 | (Not listed) | Feed roller slip | Increase pressure spring tension to setting #4. |
Keep the guide bar groove clean and the oil hole open to prevent overheating. woodzig model 40268 manual updated
Using corded power tools requires strict adherence to safety protocol to prevent shock, lacerations, or mechanical failures. Work Area Management | Code | Meaning (Old Manual) | Meaning
Lightweight design and electric power reduce operator fatigue. | | E-07 | Sensor fail | Hall
Rotate the red tensioning wheel clockwise to tighten and counterclockwise to loosen.