To change parameters or perform a calibration, you must enter the security menu using the magnetic wand. Swipe the wand over the switch for 3 seconds.
Route a 3-core shielded cable through the chosen conduit entry. Connect the wires to the main terminal block: Terminal 1: +24V DC (16 to 32V DC range) Terminal 2: 0V DC / Ground Connect Signal: Xnx Universal Transmitter Quick Start Guide
| Terminal | Label | Function | Connection | | :--- | :--- | :--- | :--- | | 1 | V+ | 24 VDC Power | +24V from PS | | 2 | V- | 0 VDC Power | Common/RTN | | 3 | S (4-20) | Analog Signal Out | PLC Analog Input | | 4 | T+ (RS-485) | Modbus A / Data + | D+ / TX+ | | 5 | T- (RS-485) | Modbus B / Data - | D- / TX- | | 6 | SHLD | Cable Shield Drain | Earth Ground | | 7 | ALARM NC | Normally Closed Relay | External Siren/Light | | 8 | ALARM COM | Relay Common | Power source for alarm | | 9 | ALARM NO | Normally Open | Default wiring | To change parameters or perform a calibration, you