The G-Force panel relies on data from sensors to make automated decisions. Proper wiring of these sensors is essential for accurate control.
Carefully lift the panel assembly into position using a team lift or hoist. Pass the mounting bolts cleanly through the center of the rubber isolators. Mount the remaining half of the isolator on the backside, then thread and secure the stainless steel hex nuts. 3. Electrical and Signal Wiring gea+gforce+panel+manual+install
Use shielded, twisted-pair cables for pressure transducers and temperature probes. Connect the shield braid to the chassis ground rail at the panel end only to prevent ground loops. The G-Force panel relies on data from sensors
: Temperature converters and sensors should be mounted on the skid or in close proximity to the ICTD sensors to ensure accurate readings. 3. Manual Installation Procedures Pass the mounting bolts cleanly through the center
All field wiring must enter the enclosure through the bottom-entry conduit cutouts to maintain the internal drip-proof seal. Keep high-voltage AC lines completely separated from low-voltage DC signals. Analog Sensor Wiring